Hi Since it's a pulse system, and you get to position your pulse for maximum effect, I don't see any reason to generate CW power. Simply mimic the lowest power slave in the chain. There's very little redundancy with Loran, so spoofing one station will mess it up. No need to mask the entire chain. At most you would need to hit two low power slaves.
Math wise: Wavelength is 10,000 ft / 3,000M. Throw things off by ~10% of that and you have problems in a harbor. You would need to play a bit to see weather a pulse every so often does the trick or not. Is that 20 db below the slave or not ? You'd have to play with it. It's in that range. A spoof that says they are on the other side of the world isn't going to work. One that says you are on the north side of the channel (when you are on the south side) is what would work. Power within a pulse set at a 5:1 duty cycle. For a 50,000 us GRI you have another 50:1. For longer GRI's you might add another 2:1. Net is a peak to average ratio of 250-1000 to 1. Put another way, a 500W pulse is ~ 1 average. Power at 100 KHz = what's in a fairly cheap switching power supply. Plug it into the wall. A couple hundred watts (or even KW) pulse is cheap. Say you have 120W out of the wall (or a car battery). If the math above is correct and you can run 80% efficiency, that's a pretty powerful pulse. It's probably cheaper to generate something at 50:1 rather than the whole > 200:1. A 5KW is a *lot* of RF, even into a simple antenna. Antenna - there's a couple ways to do that. All of them are tradeoffs (size / cost / power). The cheap way is to use a wire that's already thereā¦. Since you don't need to propagate (near field), the antenna efficiency could be higher than you would think for some antennas. Is it easier than that with some smarts involved in the pulse - probably yes. Do the smarts raise the hardware cost significantly? - you'd have to build a few and find out. What really drives this or that Loran receiver nuts? I'm quite sure you could work that out with one to play with. Am I gong into the Loran-C jammer business? No, so don't contact me off list to buy one. The point is not *have* I built one, but could one be built easily. Bob On Jul 28, 2013, at 1:29 PM, "Poul-Henning Kamp" <p...@phk.freebsd.dk> wrote: > In message <dab33aef-98ef-4503-89a7-657f0d25a...@rtty.us>, Bob Camp writes: > >> I'm not talking about taking out Loran-C over the entire North Atlantic. >> The target is a harbor sized area. For that, you certainly do not need a >> 600' antenna or megawatts of power. > > No, you need about 600W (continuous) and a loop-antenna about 5m in diameter. > > Do the math, It's not as easy as you think. > > -- > Poul-Henning Kamp | UNIX since Zilog Zeus 3.20 > p...@freebsd.org | TCP/IP since RFC 956 > FreeBSD committer | BSD since 4.3-tahoe > Never attribute to malice what can adequately be explained by incompetence. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.