OK, I believe you Mark. I do wonder why the DAC and OSC traces on Authur's unit are much smaller than mine though. Seem to be in the same units. I'll check it in a month or so.
I was thinking last night that it wouldn't be much to move the antenna over to where it's open straight up and to the south too. It's blocked a bit to the east and west though, not much I can do about that unless I get it up about 80'. Wow, 200' huh. If that's the case, I can move that antenna around over by the property line which is only about 100' from the room. Trouble is it's completely in the trees there. Maybe I should just pay a surveyor and be done with it. I've got a couple other property lines I need marked too and they're more like a half mile away. Dave ----- Original Message ----- From: Mark Sims To: time-nuts@febo.com Sent: Tuesday, September 10, 2013 9:03 AM Subject: [time-nuts] New NTBW50AA Again, THE TEMPERATURE SENSOR IS NOT BROKEN!!!!!!!!!!!!!! The firmware in some of these units (those from NTPX modules) does NOT read the temperature sensor in high-res mode. ------------------------------------------ Your temperature plots look like mine. I suspect the other unit has a broken temperature detection chip. I've seen that happen on TBolts. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.