Given the relatively low currents needed by the clock
motor, and the relatively high currents that can be
sourced/sinked by the arduino, and the fact that the
motor winding is floating relative to the arduino,
one could probably connect the motor like this:
D0---SomeResistor--MOTOR-----D1
Then, how to describe the way to drive it?
Well, starting out with D0=D1=0,
Set D1=1, then in 0.1 sec set D0=1.
Wait 0.9 sec then:
Set D0=0, then in 0.1 sec set D1=0...
Wait 0.9 sec then:
wash rinse repeat...
-Chuck Harris
Jim Lux wrote:
On 1/19/14 9:17 AM, Chuck Harris wrote:
The usual quartz clock that runs off of a AA cell is a little
trickier to drive than you might think. You need to feed
its stepper motor coil with an alternating +1.5V and -1.5V pulse.
The pulse follows the rising or trailing edge of a 1/2 Hz square
wave. I have driven them using a series capacitor and resistor
to ground...arranged as a differentiator, but I don't recall the
part values anymore.
You arduino could certainly be made to generate such a pulse using
a couple of resistors and a couple of digital outputs in a simple
DAC sort of circuit.
Yeah.. that *is* the challenge.
Use two outputs and make a sort of "H bridge"
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
