Brian, It would seem that while you are winding the clock, the pendulum could be measured by the use of the same coil that syncs it. That way you would sense the run down and over a short period after the clocks been wound speed up to re-align the tick. I could imagine a coil below the pendulum and perhaps every other second it senses the pendulum and the next second it pulse the pendulum to realign and power the clock.
If you feed energy to the pendulum why do you need weights? (May have just gotten into trouble here). Regards Paul WB8TSL On Fri, Jan 31, 2014 at 7:23 AM, Brian, WA1ZMS <wa1...@att.net> wrote: > Mike- > > Yes, I was wrong. The idea of constant driving power was around. Sadly > most of these early American tall clocks with often sand filled weights > used a simple design since as you noted cost was important and raw metals > such as brass was hard to produce locally and often imported from Europe. > > I think the best I can do is to use the basic design from the article that > David noted and will have to adjust the clock once a week after winding. > > -Brian, WA1ZMS/4 > iPhone > > On Jan 31, 2014, at 4:33 AM, mike cook <michael.c...@sfr.fr> wrote: > > > > > Le 31 janv. 2014 à 06:06, Brian, WA1ZMS a écrit : > > < snip> > >> > >> "Modern" pendulum clocks have a modified gear drive where the > >> > >> escapement is still being driven while the main wheel is being advanced > >> > >> to wind the weight cable. Not the case for 200+ year old clocks. > >> > >> > > > > It is not so much the case that it wasn't available as not always > implemented . The problem, and its solution "maintaining power" had been > addressed by many since Christian Huygens in the 17th C. and also John > Harrison , the inventor if the marine chronometer in the mid 18th C. > Similarly the principle exists for spring wound clocks, but is often > omitted to keep the price down. > > > >> > >> Regards, > >> > >> -Brian, WA1ZMS/4 > >> > >> > >> > >> > >> > >> _______________________________________________ > >> time-nuts mailing list -- time-nuts@febo.com > >> To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >> and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.