These commands are entered while LH is up and running, not on the command line. See this old (September 2011) message http://www.febo.com/pipermail/time-nuts/2011-September/059113.html for example.
On Fri, Feb 7, 2014 at 5:52 AM, Michael Baker <mp...@clanbaker.org> wrote: > Thank you Azelio, for your response to my question > regarding how to get Lady Heather to display the > signal-strengths vs AZ and EL. > > I have been trying to figure out how to get LH to display > the signal strength diagram. I have been entering > 'SAS' <ret> into the command line. LH responds by > clearing off the ADEV lists but then starts the ADEV lists > all over again. > > Where do the SAS, SAD, SAE, SAA, SAW, SAC commands > and their function explanation appear? > I do not see them listed anywhere. > > What is the correct procedure for entering the commands? > > Are you saying I should enter ' SAS/SAD/SAE/SAA ' (ret)...? > > In other words, enter all the commands in sequence separated > by the forward slash (/)...? > > Thanks-- > > Mike Baker > ********************************** > > > Azelio Boriani said: > Use: > S A S signal > S A D data > S A E elevation > S A A azimuth > S A W > S A C to clear the view > > -- > "The duty of a Patriot is to protect his > country from its government." - Thomas Paine > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.