I hope this is not too OT.
I have acquired a 3.0GHz original Channel 3 board for my Agilent 53132A counter. When installed, it reads four times (4x) the actual frequency. I'm wondering if anyone has any experience with such an installation and can point me to some setup item or zero ohm resistor I'm supposed to install. All that the manual says is to have it done by the factory. That will cost me more than the board itself. Many thanks. Jim Robbins N1JR _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.