Hi Ed:
I don't know. When I got the unit the batteries had been removed. The power supply consists of two 723 based voltage
regulator curcuits the first to drop the line voltage to about 20 V (float charging 3 each 6 V Gell Cells) and the
second 723 circuit to take in battery voltage and supply a lower voltage to run the unit.
The key problem was the short distance between the batteries and the hot oven. Maybe the oven was also heating the
batteries. Something to keep in mind today.
Have Fun,
Brooke Clarke
http://www.PRC68.com
http://www.end2partygovernment.com/2012Issues.html
http://www.prc68.com/I/DietNutrition.html
Ed Palmer wrote:
As I understand it, the only time that any sealed lead acid battery will vent is in the case of gross overcharging.
The battery is designed so that normal charge rates and correct float voltage will result in recombination of any
hydrogen and oxygen produced. Was there a fault in the charging circuit or perhaps, the charging circuit didn't have
proper temperature compensation of the charge voltage?
Ed
On 7/28/2014 10:56 AM, Brooke Clarke wrote:
Hi:
Using lead acid batteries and a precision frequency standard is not a good
thing if they are too close together.
A number of decades ago (before the Time Nuts or the internet) I was able to purchase a rack mount Gibbs 5 MHz double
oven frequency standard that used a very nice Bliley glass tube crystal because it was not as precise as is was
supposed to be. It used GelCell backup batteries that were physically in the same rack chassis as the oven. The
fumes from the batteries when charging etched some traces off the PCB inside the oven defeating the temperature
control but leaving the oscillator. It took a long time to reverse engineer and repair it. I've added a photo of the
cord wood construction of the cylindrical oscillator. The core of the cylinder holds the glass bottle crystal and
the glass piston coarse tuning capacitor, surrounded by the first heater, circuitry for the oscillator and dual
temperature control circuits on ring shaped boards. These fit inside a cylindrical cavity which is the outer oven.
I've added a photo of the inner assembly at:
http://prc68.com/I/office_equip.html
Have Fun,
Brooke Clarke
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.