Ok, did the math, a 4ns risetime should be ok on a 200MHz scope. You likely won't see the oscillations and reflections visible in Toms 58503A plots for example, they are faster than the risetime.
Bye, Said Sent From iPhone > On Sep 14, 2014, at 8:35, Said Jackson via time-nuts <time-nuts@febo.com> > wrote: > > Peter, > > You don't need nor do you want a 50 ohms end-termination on a > series-terminated 50 ohms coax cable. > > This has been discussed here extensively before, please check the archives. > Your last sentence is not correct. > > Also, you are running into your scope's BW limit if you are measuring a 4ns > risetime with a 200MHz scope.. > > Bye, > Said > > Sent From iPhone > >> On Sep 14, 2014, at 6:19, "Peter Reilley" <pe...@reilley.com> wrote: >> >> My rise time is about 4 nS. I am measuring that with my 200 MHz >> scope. I am only using 50 Ohm termination, anything else is not >> valid when using 50 Ohm coax. >> >> Pete. >> >> >> -----Original Message----- >> From: time-nuts [mailto:time-nuts-boun...@febo.com] On Behalf Of Tom Van >> Baak >> Sent: Saturday, September 13, 2014 10:34 PM >> To: Discussion of precise time and frequency measurement >> Subject: Re: [time-nuts] Correcting jitter on the 1 PPS signal >> fromaGPSreceiver. >> >>> The cables are not exactly the same lengths. Differences in length >>> will result in a fixed offset. I am not concerned about such fixed >>> errors, only jitter. >>> >>> I am comparing the rising edges which is what the spec defines as the >>> reference edge. >>> >>> Pete. >> >> Pete, >> >> Correct, the survey position is determined only by the phase center of the >> antenna, not by cable length. And cable length mismatches should make no >> difference in your jitter measurements. >> >> But one thing to check is how sharp the 1PPS rising edge is -- right at the >> input to your TI counter. I use a BNC tee with one leg open allowing a >> 'scope check (set to 1M input). If your risetime is a couple of ns like mine >> is, then all is well. Slow risetime can be a huge source of timing jitter. >> Check both 50R and 1M at the counter input. Use DC, not AC coupling. Use >> fixed trigger, never auto-trigger. Pick a trigger level that matches the >> maximum slope. >> >> Some examples of good/bad GPS 1PPS risetimes: >> http://leapsecond.com/pages/gpsdo-rise/ >> >> /tvb >> >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.