Hi http://www.cnssys.com/files/M12+UsersGuide.pdf
On page 46 there is a pretty good chart for signal strength to c/n. The chart for the Motoroal GPS module in yours should be quite similar. If there is no SCPI then it’s a “feature enhancement” in a later version of the firmware. Are you looking at the data with a terminal program or via Z38xx? If it’s through Z38xx the program is probably converting things for you. >From the screen shot it looks like your are running a terminal. Sending: *CLS will clear the error message at the top of your screen ... Bob > On Dec 14, 2014, at 2:57 PM, Dr. David Kirkby (Kirkby Microwave Ltd) > <drkir...@kirkbymicrowave.co.uk> wrote: > > On 14 December 2014 at 19:52, Bob Camp <kb...@n1k.org> wrote: >> Hi >> >> SS is signal strength. There is a setting somewhere buried deep in the SCPI >> to switch the display units. >> >> Bob > > I guessed SS probably was signal strength, but what values are good > and bad? There's nothing in any manual I can find that mentions SS on > the 58503A. I can't find any SCPI command that is supposed to switch > the display units. > > Dave > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.