David, I am surprised at the lack of interest in your divider boards. These are great units and a very useful addition to shop frequency standards. I fit my board into a former NTSC TV distribution amplifier housing and used the DA's already present to distribute 1, 10, and 100 MHz. A front panel rotary switch and BNC allows selection of 1 Hz to 100 kHz square-waves. Along with your board, there was room internally for a 1 MHz sine-wave filter and a 10 to 100 MHz multiplier. By adding a switching convertor, the former NTSC DA's power supply was adequate to power all internals. I have found this to be a very useful device. You obviously spent a great deal of time on the design of the circuitry and upon getting the board manufactured and distributed. Please accept my sincere thanks. I recommend it highly to others.
Best regards, Bruce, KG6OJI _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.