I have added this info to the wiki: http://www.ko4bb.com/dokuwiki/doku.php?id=precision_timing:fe5680a_pin-out
Thanks Didier KO4BB On Sat, Feb 21, 2015 at 2:25 PM, Bob Camp <kb...@n1k.org> wrote: > Hi > > Just so it goes into the archives. Here’s the pinout for the FE-5680B with > a 15 pin connector on it. > > Marking shows as part number 2616000-51604 > > Pin Function > 1 >= +15V power in (likely the same spec as 5680A) > 2 ground > 3 +5 power in (for some, but not this one) > 4 ground > 5 RF out (for some, but not this one) > 6 spare > 7 ground > 8 0 to 5V(?) analog tune in (for some but not all, I’d > *guess* not for this one) > 9 factory use only > 10 ground > 11 1 pps out (for this one, but not all) lvttl > 12 lock indicator (open collector) > 13 reset (lvttl input, active high) > 14 serial in (lvttl) > 15 serial out (lvttl) > > Yes, this is in answer to a question Skip asked back in 2009. Replying to > that thread might > cause something to explode somewhere :) > > They seem to be up on eBay for $45 at the moment, along with the info > above. No idea if this batch > is any good. I haven’t bought any. I’m sure the question of pinout will > come up again in about > 2 years time. By then the listing and the info will be long gone. > > Bob > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.