There are two LED's on the circuit board next to the power supply module.
One is green blinking. I'd never seen the other one on.

I needed to get them off of my bench power supply and onto a permanent
supply. I tried a 24V  3A supply. They must have been cheating a little on
the ratings. The voltage dropped down to about 16V when the oven heaters
fired up. I noticed that the mystery LED was lit. It's red. A good guess is
that it's a power fault indicator. The LED's are next to the black power
supply module. A picture is attached.

Also, Below is a link to some plots from Ulrich Bangert's Z38XX software of
the initial day of operation. The units had about 30 minutes of run time
before I got a permanent power supply, GPS Antenna  and RS-422 connection
set up. I thought it was interesting to see the graph of the EFC Value
slowly flattening out. I guess if I was asleep for 15 years It'd probably
take me a while to get going too :-)

http://mesterhome.com/timenuts/gpsdo/

-- 
Luke Mester
http://mesterhome.com/
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to