I used the output of a CMOS frequency divider to drive a capacitor coupled passive dual diode and resistor plus a parallel tank circuit comprising a 1uH powdered iron core (amidon #6) inductor and a 100pF silvered mica capacitor. The ADC used a 100MHz clock which also drove the frequency divider chain. The idea being to evaluate the performance of the ringing LC circuit and minimise the influence of the 100MHz ocxo. A BAW crystal could be used as a filter replacing the SAW filter used by Panek. Bruce
On Wednesday, 17 June 2015 8:20 PM, Attila Kinali <att...@kinali.ch> wrote: On Wed, 17 Jun 2015 09:32:23 +1200 Bruce Griffiths <bruce.griffi...@xtra.co.nz> wrote: > > Do you mean the technique that Panek et al. [1] are using? > > Not quite he used an impulse to excite a saw filter rather than switching > off the dc current feed to an inductor or the equivalent. Is there any fundamental difference there? > > IIRC he got that down to 0.5ps RMS now. And yes, the major > > source of error is the oscillator, according to [2]. > > Ripamonti et al. showed in [3] that using an LC tank instead of an SAW > > filter will result in something in the order of 2-10ps RMS (after > > temperature compensation). So this system is in the same region as an > well > > designed time-to-amplitude converter based system. > > > The curve fitting algorithm they used is somewhat deficient as is the > switching method employed one can do much better provided one has > sufficient time or computing resources available. Can you give a description what you would do differently? And yes, the two authors look like fresh graduate students who were told by their professor to see whether they can reproduce Paneks results without using a SAW filter. > My crude testing using a > somewhat simplified diode switched current source powered by the signal > itself achieved a fitting noise of around 5ps with a 14 bit ADC. A better > driver and higher resolution ADC with a lower noise input amplifier than the > input amplifier of the oscilloscope I used should improve the results > somewhat as would a better model for the damped sine signal. Hmm.. but the diode switched current source would need a quite steep input pulse, wouldn't it? So some kind of pulse shaping would be needed for a general circuit. I also played with the idea to use a overtone crystal oscillator instead of an LC tank, as this would probably give a higher temperature stability. Attila Kinali -- I must not become metastable. Metastability is the mind-killer. Metastability is the little-death that brings total obliteration. I will face my metastability. I will permit it to pass over me and through me. And when it has gone past I will turn the inner eye to see its path. Where the metastability has gone there will be nothing. Only I will remain. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.