Ulrich, You can buy the MS connector from Digikey, Mouser, etc. Some practical time-nuts just rip out the expensive mil-spec connector and install a normal IEC connector. Or, if you're brave, just remove the bottom panel and use jumper wires to deliver 120 VAC directly to the pins. But, very important, make sure you've got the right pins.
See http://leapsecond.com/museum/hp5065a/conn.htm for details. /tvb ----- Original Message ----- From: "KA2WEU--- via time-nuts" <time-nuts@febo.com> To: <time-nuts@febo.com> Sent: Thursday, March 17, 2016 7:29 AM Subject: Re: [time-nuts] Fw: 5065 > > The HP 5065A Rubidium Frequency Standard requires a circular 3 pin adapter > cable that can be plugged into 115V AC outlet. > I checked all cables I have and this particular cable is not finable. Can > the unit set to 110/220 V > Maybe this cable can be purchased or assembled ? ULRICH > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.