Hoi Rick, I don't know which phase noise measurement sturcture you are going to use exactly or what your goals are, so I am guessing here a little bit...
On Fri, 10 Jun 2016 17:15:22 -0700 "Richard (Rick) Karlquist" <rich...@karlquist.com> wrote: > I am now putting together a modern homebrew phase noise system. > I am planning to use a ZRPD-1 phase detector driven by AMC-123 > amplifiers. The phase detector will drive a SpectraDAQ-200 digitizer > with SpectraPlus-RT FFT software. >From the specs of the SpectraDAQ-200 it looks like they just employ some audio codecs for the sampling. This has two consequences major consequeces: 1) The performance below 10-20Hz will be bad (yes, they spec the cut of frequency as 2Hz, but the audio ADCs are usually not spec'ed below 20Hz). 2) Due to the way these ADCs are built, the noise above 20kHz will be a lot higher than below (aka noise shaping). If this is ok for you and you actually want to use an audio ADC, but then I would recommend using one of the USB "soundcards" out there. I doubt that the SpectraDAQ-200 is anthing more than an implementation of the evalboard circuit with BNC connectors. You can get very good soundcards already for 30€. 100€ should already buy you one that is about as good as these things can get. The only thing you need to have an eye on is, if you need two inputs that the microphone input is stereo, which should be the case, but is not necessarily given. Alternatively, I would suggest using one of the modern sigma-delta or SAR ADCs, which can deliver increadibly high ENOB and SNR at astonishing sampling rates. Good candidates might be: AD7982, 18bit 1Msps AD7984, 18bit 1.33Msps LTC2378-20, 20bit 1Msps LTC2368-24, 24bit 1Msps Eval boards for these are available (between 100 and 200€) and interface with SPI. You can either use an USB SPI dongle (between 5 and 50€) or use a small uC board to interface with the PC. Saving the samples in a wav file and using one of the many FFT tools shouldn't be a problem. If you don't mind designing your own board, then you can go for something like the LTC2386-18 which offers 18bit at 10Msps (and still 96dB SNR) and enjoy a very wide frequency range. But the requirement of LVDS input might be a killer. Attila Kinali -- Malek's Law: Any simple idea will be worded in the most complicated way. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.