If the unit is low on amplitude, there isn't likely much more than a buffer amp between the ocxo and 10 MHz output.
On Tue, Nov 29, 2016 at 7:54 PM Bob Camp <kb...@n1k.org> wrote: > Hi > > There is no schematic for the TBolt available. Based on Trimble’s approach > to keeping > all their IP private (look at the survey side …), there will not be a > schematic coming out > from them. Since a good chunk of the functionality is in the FPGA’s and > CPU’s, a schematic > may be a tough thing to come up with by tracing this and that on the board. > > Bob > > > On Nov 29, 2016, at 6:38 PM, Richard W. Solomon <w1...@earthlink.net> > wrote: > > > > From the last e-mail I saw in 2014, there was no schematic available. > > > > > > > > Has anything changed lately, is one available ? > > > > > > > > I have one with low output that I would like to take a crack at fixing. > > > > > > > > Thanks, Dick, W1KSZ > > > > _______________________________________________ > > time-nuts mailing list -- time-nuts@febo.com > > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.