Mark Thank you for the secret on setting the receiver I was making it way to hard. The 3801 absolutely has a problem. Locks and everything just fine. Takes about 20 minutes from a cold start. It will accept commands I am not getting the correct output back. Everything had worked so it is a real problem. I used any number of programs with it. HP satstat gpscontroller and other old programs. So none of that is sick. The output is 0 to 3V approx and its a LT1180 so it should be +- 5V at least and more like 7. So somethings sick. Its on the bench and will scope it out. Thanks again for your fine work. Paul WB8TSL
On Sun, Dec 11, 2016 at 12:18 PM, Mark Sims <hol...@hotmail.com> wrote: > At the bottom of the command line help screen dialog, it should show what > command was causing problems. > > You should not need to do anything. Z3801A should be auto-detected. You > can skip the auto-detect by editing the heather.cfg file and changing the > /rxa command to /rxz > > Are you using a null modem cable with the Z3801A... it needs it. Also do > you have the proper serial port selected? If you have a /br command > setting the baud rate, that would override Heather's auto-detect trying > different baud rates or the /rxz command setting 19200:7:O:1 > > ----------------------------- > > > I am trying to use Heather with a z3801. I have tried numbers of > combinations of what should set the system to the Z receiver. But none seem > to work. It immediately brings up the help screen and I assume that says > the command is bad. > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/ > mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
