On Fri, Dec 09, 2016 at 08:25:52PM -0800, Chris Albertson wrote: > Lowest price I've found is BasicPCB.com They charge $3 per > square inch for 2 layers with mask and legend.
OSHpark charges $5 per square inch for the standard 2 layer order (which include three boards, i.e. actually 3 square inch or $5/3 per square inch) including mask and silk screen on both sides, no limit to vias or general drill hits but unfortunately no electrical check. > Minimum is three boards of 1 square inch. So you actually > can place a $9 order with them. You can get a a lot lower with OSHpark there, I had orders below 2 USD and they ship for free, worldwide. > They are a USA based company. OSHpark too. > They accept standard Gerber files. Besides Gerbers, they also process KiCad and Eagle design files. > This is very impotent as a few others like PCBexpress make > you use their proprietary layout software and then you are > locked into that company for production runs too. Yes, nasty. > You need a workflow that uses Gerber files. Best, Herbert > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.