Thanks, I will look on Tom's site for the manuals. The last time I looked into this, I think all I saw were copper cavities.
But I think some sort of design that required very minimal machining, and much more "plumbing", would be what I would need to do a homebrew maser :-). Tim N3QE On Tue, Jan 3, 2017 at 1:14 PM, <cdel...@juno.com> wrote: > Tim, > > The EFOS2 uses an Aluminum cavity! So machining would be easier than > Copper! > > The complete manuals with schematics are on Tom's Leapsecond.com site. > > Making a homebrew Maser was bandied about a few years ago on TimeNuts. > > Cheers, > > Corby > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/ > mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.