Hi I suspect that there are (or will be) some other cheaper / easier ways to do the same thing. The signal to noise requirements in the RF chain are sensitive to a couple of things, but not to an absurd level. You do need good close in noise. I would not even bother to go for a “final” RF section until the physics stuff had been worked out. Designing today vs designing in a couple of years will always be the more expensive approach. For the lash up, I might well gut parts out of an existing cheap Rb simply to get things going …. who knows. Maybe we would need a chain like the one in the paper to figure out what is going on. In four years take a look at what is on the market and make some decisions about the “final” RF chain. Even then you might revisit it several years after that due to cost or performance issues….
This does get back to “state of the art Rb” and what that means. In my suggested case that’s measured in terms of ADEV for Tau = 1 to 1,000,000 seconds. If you wanted an Rb with (only) state of the art phase noise at 1 MHz offset … that’s a different thing. State of the art for power consumption and size is also not what I’m suggesting in this case. Why the choice of spec? … this is TimeNuts. For some guidance on what state of the art in Rb’s *is* in this area, check out the many papers on the GPS Rb’s published in in the ION conference proceedings. Can a bunch of hackers do quite that well? … likely not. They have been fiddling with that design for many decades. They also have a pretty healthy budget to produce each one they build. We certainly can try to get as close as we can. Testing ours in orbit *might* put a strain on the budget though :) Bob > On Jan 10, 2017, at 9:15 PM, Bruce Griffiths <bruce.griffi...@xtra.co.nz> > wrote: > > A possible RF chain for a Rubidium standard using off the shelf parts plus a > couple of custom microwave filters:https://arxiv.org/pdf/1204.4215.pdf > > Bruce > > On Wednesday, 11 January 2017 2:10 PM, Bob Camp <kb...@n1k.org> wrote: > > > Hi > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
