Yes, It is easy if you have an Arduino handy. Write a scratch to try EVERY address one at a time. Print the currently attempted address top the screen
In fact there is a pre-written sketch in the IDE's I2C examples folder. You can run that and it will report what it finds. It just tries reads on every possible address. On Tue, Jun 20, 2017 at 6:02 PM, Tom Miller <tmiller11...@verizon.net> wrote: > Has anyone been able to get the Packrat software to work with a display? I > have been successful getting the Arduino board to initialize the > Trueposition board but can't get the display right. > > The problem seems to be getting the I2C addressing correct. There are > several 16x2 line displays available but they address at 0x20 to 0x27 and > 0x38 to 0x3F. Neither of these work. > > Since we do not have the source, is there any way to find out what address > is in use? > > Regards > > ----- Original Message ----- From: "Gregory Beat" <w...@icloud.com> > To: <time-nuts@febo.com> > Sent: Tuesday, June 06, 2017 8:44 PM > Subject: Re: [time-nuts] TruePosition on the Arduino > > >> Ben - >> I assume that you never received the Arduino "C code" >> written by Bruce, WA3YUE for the original project? >> >> Club's Powerpoint presentation indicated that source code was available. >> http://www.packratvhf.com/techinal.htm >> >> Packrat GPS Project (Gary, WA2OMY; Bruce, WA3YUE; George, KA3WXV) with >> TruePosition GPSDO and Arduino >> by The Mt. Airy VHF Radio Club "Pack Rats" (Southampton, PA). >> http://www.qsl.net/wa2omy/A%20Packrat%20GPS%20Receiver%20Project.pdf >> >> greg, w9gb >> == >>> >>> original message / digest < >> >> I'm getting to the point that once I've got the button logic working, I'll >> send out my source to anyone who wants to take a look at it or use it. >> I will stipulate one condition - you can't make too much fun of how poorly >> programmed it is. ;) >> thanks much and 73, >> ben, kd5byb >> == >> Sent from iPad Air >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. -- Chris Albertson Redondo Beach, California _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
