Hi Mark,
I take that as "challenge accepted". :)
Have fun, lots of fun! :)
Cheers,
Magnus
On 07/20/2017 02:44 AM, Mark Sims wrote:
I am still getting to know the device. Heather can calculate a least squares
trend line and FFT of any plot (and now also a histogram) but I have not tried
to calculate the temperature sensitivity yet.
Heather's temperature control PID will work with any device that reports a
temperature. I don't know how well it will work the the PRS10 since the
message polling loop takes 25 seconds to cycle through all the readings. The
TT timetag and FC frequency control values have a high priority and are polled
once a second. I could add the temperature to the high priority values, but
that would really increase the time required to update all the values... I'll
try that and see what happens. I could probably only add temperature to the
high priority messages if the temp control pid is enabled.
--------------
Have you done a least-square fit to determine the sensitivity?
Have you considered the LH approach to stabilizing it?
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
