On Sat, Jan 28, 2017 at 5:53 PM, Mattia Rizzi <[email protected]> wrote:
> Have you tried to use clock distribution components like 5PB1108? You could > use that to distribute the LT1711 output to the output stages > *independently*. You could use also 5PB1108 as output stage as well (but > this depends on your output voltage level), I got like >3V/ns on a 50ohm > with 6 outputs tied together. For fine alignment a variable capacitor (or > RC filter) at the output stage's input pin may do the job. > Hi Mattia, everyone, I now had time to assemble a few distribution amplifiers using IDT5PB1108 (see [1], left side). With my skills in length matching the traces (using Kicad) I still get around 200ps peak-to-peak output skew between channels. The chip datasheet spec is <50 ps pin-to-pin skew. So now I tried adding a trimmer-cap on the input of the output-buffer. I tried both 50pF and 10pF, but it seems 10pF gives a 500ps delay-tuning range which is sufficient. When tuning all channels to within 20ps P-P one day, I then got 50 ps P-P when verifying this the next day. Using BNC-cables and an SMA-BNC adapter on the output might not be the greatest choice for picosecond repeatability... I did the measurements with a 53230A and the reported values are the average of 30-60 s of 1PPS pulses. Some images with the board and results here: http://www.anderswallin.net/2017/09/delay-tuning-with-trimmer-caps/ I also opened up a commercial pulse-distributor, and it has the same kind of trimmer-caps before the output-stages. It measured 28 ps peak-to-peak among 16 output channels. I will incorporate a trimmer-cap into the next version of the "PDA" design and publish on ohwr - when I have time.. Anders [1] https://www.ohwr.org/attachments/5339 _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
