Hi Philip, S200/S250 share the same F/W and OS files on the CF Card (V1.30 currently). The out 1PPS, and 10mHz are there now, and it is my understanding that although the unit always defaults to GPS, it also constantly checks for any usable, valid sync signals from any source... including those 1PPS, 10mHz, and IRIG inputs, so pretty sure it's already good to go. Could always be wrong of course :) Will update as I get the jacks in, and tested.
Martin Re: [time-nuts] S200 to S250 Conversion to in/outsPhilip JacksonWed, 04 Oct 2017 07:01:54 -0700 Have you tested this approach?The firmware will need to recognize the new hardware configuration to enablethe 250's additional sync input options and I'm not sure how just addingjacks would be something that could be sensed reliably by the chipset?ThanksPhilip-----Original Message-----From: time-nuts [mailto:time-nuts-boun...@febo.com] On Behalf Ofmart...@soundtech-lg.comSent: Tuesday, October 03, 2017 4:25 PMTo: time-nuts@febo.comSubject: [time-nuts] S200 to S250 Conversion to in/outsQuite easy to accomplish!Signals 1PPS and 10mHz are sitting untapped at the jack signal traces onthe board.You could put any 50 ohm BNC jacks there. However here is the correctdual jack part to install (3 req'd).Search Digikey for their part# ARF2115-NDVoila! Instant S250 !!! all the gozintas, and gozoutas.Hope this has not already been discussed!Martin_______________________________________________time-nuts mailing list -- time-nuts@febo.comTo unsubscribe, go tohttps://www.febo.com/cgi-bin/mailman/listinfo/time-nutsand follow the instructions there._______________________________________________time-nuts mailing list -- time-nuts@febo.comTo unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nutsand follow the instructions there. Previous messageView by threadView by dateNext message [time-nuts] S200 to S250 Conversion to in/outs martinm + Re: [time-nuts] S200 to S250 Conversion to in/outs Philip Jackson Reply via email to The Mail Archive hometime-nuts - all messagestime-nuts - about the listExpandPrevious messageNext message _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.