Hi One of the TimePods that I had access to in the past was particularly good at telling you it was sitting on top of a power transformer. It didn’t matter a lot which instrument the power transformer was in. For some weird reason it was a good magnetometer at line frequencies. I never bothered to send it back for analysis. Simply moving it onto the bench top (rather than stacked on top of this or that) would take care of the issue.
As far as I could tell, it was just the one unit that had the issue. None of the others in the fleet of TimePods seemed to behave this way. Given that they normally are very good at rejecting all sorts of crud and ground loops, it was somewhat odd to see. Bob > On Feb 26, 2018, at 7:13 AM, Tom Van Baak <t...@leapsecond.com> wrote: > >> BTW: Do you know the cause of the oscillations in the 5065 vs BVA plot? > > The ADEV wiggles aren't visible with normal tau 1 s measurements. But since > the TimePod can go down to tau 1 ms, when I first measure a standard I like > to run at that resolution so effects like this show up. Once that's done, 1 > ms resolution is overkill. > > In this case it appears to be power supply noise. Attached are the ADEV, PN, > and TDEV plots. > > The spur at 120 Hz is massive; there's also a bit at 240 Hz; almost nothing > at 60 Hz. When integrated these cause the bumps you see in the ADEV plot. > It's best seen as a bump at ~4 ms in the TDEV plot. > > Note the cute little spur at 137 Hz. Not sure what causes the one at ~3630 Hz. > > /tvb > <5065a-adev.png><5065a-pn.png><5065a-tdev.png>_______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
