Lady Heather has a command that lets you set the DAC voltage. It's in the "D" menu. Depending upon the firmware, you may need to disable disciplining first (also in the "D" menu). If the DAC command works to change the OCXO freq, the osc EFC and DAC are probably OK. If it does not, I'd suspect the DAC or the osc EFC input... or perhaps your firmware does no support the DAC setting command. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
- [time-nuts] Z3801A OCXO manual trimming Tom Curlee
- Re: [time-nuts] Z3801A OCXO manual trimming Bob kb8tq
- Re: [time-nuts] Z3801A OCXO manual trimming Tom Holmes
- Re: [time-nuts] Z3801A OCXO manual trimming Bruce Griffiths
- Re: [time-nuts] Z3801A OCXO manual trimming Tom Van Baak
- Re: [time-nuts] Z3801A OCXO manual trimming Bob kb8tq
- Re: [time-nuts] Z3801A OCXO manual trimming rfnuts
- Re: [time-nuts] Z3801A OCXO manual trimming Ed Palmer
- Re: [time-nuts] Z3801A OCXO manual trimming Joe Hobart
- [time-nuts] Z3801A OCXO manual trimming Mark Sims
- Re: [time-nuts] Z3801A OCXO manual trimming Joe Hobart
- Re: [time-nuts] Z3801A OCXO manual trimming Bob kb8tq
- Re: [time-nuts] Z3801A OCXO manual trimming Hal Murray
- [time-nuts] Z3801A OCXO manual trimming Mark Sims
- Re: [time-nuts] Z3801A OCXO manual trimming Joe Hobart
- [time-nuts] Z3801A OCXO manual trimming Mark Sims
- Re: [time-nuts] Z3801A OCXO manual trimming Tom Curlee