By the way, if you would like some data captured during the last run, let me know. I have an excel sheet of the peak data from spectrum lab centered on 1850hz as I use the 3586B receiver.
Regards, Jerry Jerry Hancock je...@hanler.com (415) 215-3779 > On May 11, 2018, at 10:52 AM, Jerry Hancock <je...@hanler.com> wrote: > > If you were in Connie’s back yard or had a very stable ground wave, then yes, > you could automate the testing. > > There are a number of challenges with this method as looking at the data with > a simple graph will tell. You might have large fluctuations on the high > frequency side only, for instance, that any averaging or algorithm would > assume to be valid data. > > The next issue is the length of the dataset as the key-down time is only a > few minutes so you end-up with not that many samples. > > Regards, > > Jerry > >> On May 10, 2018, at 5:59 AM, Don Murray via time-nuts <time-nuts@febo.com> >> wrote: >> >> Hi Magnus... >> >> >> Appreciate any help! >> >> I participate in the ARRL Frequency Measuring Test, >> and I would like to automate the measuring process. >> >> I have two frequencies, A and B... >> >> A is a GPS locked HP 3336B set to 455,000.000 Hz >> >> I use the 3336B instead of the 455,000Hz BFO >> signal from my GPS locked Racal receiver so >> that I can measure AM stations without the >> annoying beat note. ;-) >> >> B is an IF signal which should appear between >> 455,000.000Hz and 455,001.000 Hz >> >> I would like the 5372A to calculate the B minus A >> delta, over a manually started and automatically >> stopped measurement period of 110 seconds. >> >> I would like a delta resolution of 0.001Hz to be >> developed by the box. >> >> Now, there will be doppler. I want the box >> to analyze and give me a best statistical guess >> for the B minus A delta. >> >> BTW the B minus A delta will be added to the >> frequency of my Racal receiver to give me the >> best "guess" as to the correct frequency of the >> target signal. >> >> The Racal reads out to the Hz, and I am able to >> accurately determine if the Racal is tuned above >> or below the "target" frequency. >> >> I will be tuned below the "target" and within >> 1 Hz of the "target." >> >> I assume I will be in the one frequency mode. >> >> Can the box give me the desired resolution? >> >> What sampling period would be the best to use? >> >> What statistical result would I use as my delta? >> >> Appreciate your help. My head is spinning whenever I >> get into the operating manual! >> >> TNX... >> >> >> 73 >> Don >> W4WJ >> >> In a message dated 5/10/2018 2:19:49 AM Central Standard Time, >> mag...@rubidium.dyndns.org writes: >> >> >> Hi, >> >> What issues do you have? >> >> Cheers, >> Magnus >> >> On 05/08/2018 02:32 AM, Don Murray via time-nuts wrote: >>> Hello Time Nuts... >>> >>> >>> >>> Who is the resident expert on the HP5372A? >>> >>> I have some operational questions. ;-) >>> >>> email off list please. w4wj at aol.com >>> >>> TNX all... >>> >>> 73 >>> Don >>> W4WJ >>> >>> >>> _______________________________________________ >>> time-nuts mailing list -- time-nuts@febo.com >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >>> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.