Fellow time nuts,
Thanks to a very helpful (and generous) member of this list I now
have a Motorola VP Oncore for my 58503A. Unfortunatly, there appears to
be another problem somewhere with my 58503A. With the receiver installed
it now appears to pass its self test, at least it behaves as the manual
says it should with the power indicator illuminating immediately,
followed a few seconds later by the other lights each flashing in turn,
and then the power light alone remaining lit. At this point it should
(again according to the manual) present an 'scpi>' prompt on the serial
port, but it does not. I am sure I have the correct wiring between my
computer and the unit because I can measure the RS-232 TX line voltage
coming from the 58503A on my PC's RX line. I have tried the default
serial port settings (9600 8N1) as well as other baud rates with no success.
Figuring that, if it will lock, I really don't care if it talks to my PC
I have left it outside connected to an antenna for the last five hours
or so, but I still haven't gotten it to lock.
Questions:
1) Has anyone else experienced problems with these HP units failing to
communicate with the PC? Any solutions?
2) Is there a service manual available anywhere?
3) Does anyone know what the internal LEDs on the back of the board
mean? After powering it up and letting it sit for a few minutes the two
red ones on the far left (with the front of the receiver facing me) are
on along with the green one on the far right. The three red ones in the
middle all flash on momentarily every 15 seconds or so, then they go off
again.
4)Do you have any other hints?
-Matthew
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
