17/01/2019 14:42
I have a Ublox NEO-M8T-0-10 that in the OE state shows no output on
TP2. If I programme it with the UCentre software for say 500hZ output
I sill see nothing on TP2. Do I need to pull it high on boot or
anything to see an output please? I am not probing it with a X10 scope
probe until after it has booted, so I don't believe it's pulled low on
boot, although I can't see how a X10 probe setting could pull it
anyay. TP0 behaves normally and accepts changes in output frequency.
Otherwise it also seems to generally act correctly. Thanks
--
Best Regards,
Chris Wilson.
mailto: ch...@chriswilson.tv
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe, go to
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.
