I have also solved the same problem I have 4 Seth Thomas quartz clocks with the red 24 numbers in the display driven by a single driver with independent advance and hold for each clock. (Needed for multiple time zones) Generally reasonably quite. As mentioned they must be driven at a alternating rate. These were quartz clocks and simply drop the electronics out and keep the coil. Then have fun. The clocks were purchased at a bargain store for little and picked up a 5th as a spare. Do not recall if there were anymore left. If there had been I would have purchased them 10 years ago. Have been on the hunt and have not seen anymore. Also tried to obtain replacement clock motors on the internet. But the first purchase was not correct do not recall what it was but it was not a by-phase motor. Regards Paul WB8TSL
On Thu, Jan 2, 2020 at 3:46 PM xaos <x...@darksmile.net> wrote: > Jerry, > > The Chinese NTP server that I've been discussing here lately has outputs > for 1PPS, 1PPM and 1PPH. > > The plain vanilla NTP server (no 10MHz.) goes for 150-200. > > George, N2FGX > > On 1/2/2020 13:21, Jerry Hancock wrote: > > Hello, > > > > I looked around but can’t find a wall clock that would take a 1PPS input > signal to drive the minutes and seconds. I’ve made digital modules using a > lot of different displays but would love to have a large, 14” or so with a > second hand, wall clock that I can drive with 1PPS. The old IBM clocks, > etc I found take a pulse on the minute. I have an old pendulum clock I can > drive with a solenoid but thought I would ask here before going that route. > > > > Signal levels aren’t important. > > > > Thanks > > > > Jerry > > > > > > _______________________________________________ > > time-nuts mailing list -- time-nuts@lists.febo.com > > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- time-nuts@lists.febo.com > To unsubscribe, go to > http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.