Time-nuts- It has been a couple of years since I last worked on a 4060 so I have forgotten some of the details. Can someone remind me?
Operating the device in manual mode, I can adjust beam gain so that I get a reading. However, ramping the control voltage over its range (which does sweep the output below and above 10 MHz), the gain needle hardly moves on the front panel. Measuring with a DVM on test point E26, it does seem that the voltage increases a bit as I tune through 10 MHz, but the voltage seems a bit unstable, and the unit won't lock up automatically. I am going to check the power supply for open capacitors next. Is there anything else I should be checking towards diagnosing the problem? Thanks in advance- Jim _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com To unsubscribe, go to http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com and follow the instructions there.
