For what it is worth I ran two identical AGM 12 volt batteries for approx 7 
years or so in my home lab.   

I carefully adjusted the terminal voltage while float charging them via a 
blocking diode and checked the voltage every few months.   I also confirmed 
that the terminal voltage of each 12 volt battery was essentially the same.   
The manufacturer provided data re suitable float voltages at various 
temperatures.  The temperature in my time lab is fairly stable.

  After over six years of service they powered two of my OCXO's for approx 48 
hours during a lengthy power outage when I was not home.   It all worked as I 
expected (I had chosen the batteries to provide at least 48 hours of run time 
with some margin) and after approx 7 years I had to replace the batteries when 
it became apparent they were not charging (the power supply I charge them with 
has an ammeter which helped me realize there was an issue.)   I expect to get a 
similar life span from the replacement batteries.  The second set of batteries 
at first had a significantly higher voltage difference when being float 
charged, the battery vendor replaced either one or both of the batteries and 
all was good.

I would not be surprised if the deep discharge of the first set of batteries 
contributed to their subsequent demise.

The experience of others may differ from mine (:


Mark Spencer
m...@alignedsolutions.com
604 762 4099

> On Sep 25, 2020, at 2:06 PM, Poul-Henning Kamp <p...@phk.freebsd.dk> wrote:
> 
> --------
> Bob kb8tq writes:
> 
>> Two basic types of SLA / VRLA batteries out there: AGM and Gel. For the AGM 
>> variety, you want a bit more to your charger.
> 
> Yes, if you buy batteries for N * 100K $money, spending more money
> on your charger is a good investment.
> 
> But if you have two batteries doing float-charge/long-run/tiny-load,
> in a benign environment in a corner of your lab, the internal
> variance between batteries in that same production lot, will
> overshadow any imaginable benefit a fancy charger could bring.
> 
>> I haven't worked with Gel cells in a while so they may indeed be easier.
> 
> They are for the same reasons they suffer cyclic use better.
> 
> But for a float/long-run application, it makes absolutely no difference.
> 
> -- 
> Poul-Henning Kamp       | UNIX since Zilog Zeus 3.20
> p...@freebsd.org         | TCP/IP since RFC 956
> FreeBSD committer       | BSD since 4.3-tahoe    
> Never attribute to malice what can adequately be explained by incompetence.
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts@lists.febo.com
> To unsubscribe, go to 
> http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
> and follow the instructions there.
> 

_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe, go to 
http://lists.febo.com/mailman/listinfo/time-nuts_lists.febo.com
and follow the instructions there.

Reply via email to