I may have missed something. On my RPi 3 B+ if I plug in HDMI to a monitor after power-on there may have been a small cursor on dark screen.
On Sun, 04 Jul 2021 22:33:40 -0800, Bill Beam wrote: >On my RPi 3 B+ if I plug in HDMI to a monitor I get no display. >If I power cycle With HDMI connected then it shows up on display. >So HDMI works if connected before power-on. >Regards, >Bill >I am using the preconfigured card supplied with the unit. >On Mon, 5 Jul 2021 00:23:19 -0400, Robert DiRosario wrote: >>On the Raspberry Pi TimeHat is there output to the HDMI connector, or is >>it configured to just use a serial console? >>I'm using the preconfigured SDHC card, so the software should be fine. >>If I swap out the SDHC card with a different one the systems boots fine, >>so the hardware works. >>With the card with the software there is never any output to the HDMI >>connector. >>Based on the LED on the GPS module it's locking up on the GPS signals >>just fine. After the initial lockup, it locks up again in only a few >>seconds after a power cycle. >>Robert >>_______________________________________________ >>time-nuts mailing list -- time-nuts@lists.febo.com -- To unsubscribe send an >>email to time-nuts-le...@lists.febo.com >>To unsubscribe, go to and follow the instructions there. >Bill Beam >NL7F Bill Beam NL7F _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com -- To unsubscribe send an email to time-nuts-le...@lists.febo.com To unsubscribe, go to and follow the instructions there.