Hi, Ok, I managed to get a moment to do a few tests. I'll try to answer the questions so far, sorry if I miss something out.
For test equipment, I have the following gear of possible use: - HP 5335A 200MHz Universal Counter with 1.3GHz option - Leo Bodnar GPS Reference - HP 34461A Multimeter, just calibrated. - Tek TDS748C 1GHz Scope - Multiple HP E361xA Power supplies - 3325A Function Gen (All options) - Many other bits of gear too, including a billion TM500 modules and mainframes etc. On the 5065A front, I have replaced the resistors in the RVFR with Mil-spec Vishay RN55, RN60 and RN65 series parts, cleaned the glass elements and added a 100 deg.C thermostat to prevent over temperature events. I have replaced all the wet tantalum capacitors in the entire unit with United Chemicon KYB 220uF, 63V capacitors (10,000 hour rated), bypassed with C0G/NP0 0.1uF MLCC ceramic caps, there was no PCB damage, but two tant caps had just started leaking, luckily not reaching the PCB's. I added heat sinks to the two diodes on the A2 board and replaced the RIFA mains filter cap too. The 3 big mains filter capacitors tested well within spec, with leakage down around 10uA. - On A8 Pin9, I get 137KHz, 174mV P-P - A7 TP2 shows me random low amplitude noise - A3 TP2 I see 5.38VDC My serial number is 2432A01344 and I have the 10811-60109 OCXO (and no options fitted, so the chassis is clean of battery corrosion). Thanks all for the help! Jared
signature.asc
Description: OpenPGP digital signature
_______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com -- To unsubscribe send an email to time-nuts-le...@lists.febo.com To unsubscribe, go to and follow the instructions there.