Hi Quick way to take apart a NetRS:
1) Pull out all the screws from the front panel ( the one with the LED’s on it). 2) Pull the screws from the mounting bracket (if it’s still there). All are T10 Torx. 3) Reverse the Torx driver and use it as a small hammer. Tap the “ears” on the front panel. You don’t need to go crazy. It will pop off. The D connector on the front panel is normally attached with ribbon cable. There is no need to unscrew it. If anything, unscrewing it is a bad idea since doing so would allow the sub-cabe to the front panel to flex / break. Next use a pair of needle nose pliers to unbend the latching strap that holds the flash card in place. It’s directly above the place the ribbon cable from the front panel comes into the main assembly. Now you can unplug the flash card and replace it. On normal power up, with only power applied ( nothing else attached ). The front panel LED’s go through a series of flash flash flash stuff. Eventually they calm down and you just get a green light showing you which power input you are connected to. Normal drill is to just leave the back panel in place. Unless something is broke, there is no reason to pull it. Fun !! Bob > On Mar 19, 2022, at 4:04 PM, paul swed <paulsw...@gmail.com> wrote: > > OK have figured the main and standby power out. They work fine. > I want to check the internals of the receiver for any damage. > Have removed the front and back torx screws and front DE9 locking nuts. > But it refuses to let loose. Am I fighting a rubber grommet? Maybe I do > need to take all of the back N and BNC connector nuts off. This thing feels > very tough to open and do not want to damage it. > > Also all of the almanacs and such are totally 0. That could have easily > happened when I was doing a factory reset. Especially since the data zero > is almost exactly the same as a factory reset. > Thanks > Paul > WB8TSL > _______________________________________________ > time-nuts mailing list -- time-nuts@lists.febo.com -- To unsubscribe send an > email to time-nuts-le...@lists.febo.com > To unsubscribe, go to and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@lists.febo.com -- To unsubscribe send an email to time-nuts-le...@lists.febo.com To unsubscribe, go to and follow the instructions there.
