Yes, we did,
and learned, that the device -- the ublox6 -- forgets the the program
very fast, thus we added one arduino, which loads the program into the
ublox at every new turn on. By using low output frequency -- 10kHz --
the jitter is low, at higher output frequency the jitter is getting
larger, presumably because the internal clock of the ublox is a "free
running " crystal oscillator.
We did not do any "deep quality investigation" to the output of our
10MHz signal source output, 10 is just used as frequency calibrator for
instruments.
I made one phase phase comparation, --comparator one input GPS -ublox
derived 60kHz the other input is wwvb 60kHz from Fort Collins Colorado,
it show the typical phase change during the day of the wwvb.
73
Alexander Pummer[hard ware] + David Fannin [soft ware]
On 5/28/2022 10:05 AM, R&M Putz via time-nuts wrote:
Has anyone done anything with the Ublox GPS timing receivers? As it appears the
Navman with the 10khz outputs seem to be drying up, I'm wondering about the
Time Pulse 2 output being set to 10 Khz or 100 Khz. Thoughts anyone?
Rich
W9ENG
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe send an email to time-nuts-le...@lists.febo.com
_______________________________________________
time-nuts mailing list -- time-nuts@lists.febo.com
To unsubscribe send an email to time-nuts-le...@lists.febo.com
