-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Hi again,

I took a closer look at your mail and then I saw that you are using
127.127.28.0 as refclock. If I remember correctly 127.127.28.0 referes
to the NMEA output of gpsd. The PPS pulse is 127.127.28.1. Are you sure
that gpsd is reading your GPS as all? It can be checked by the programs
distributed along with gpsd such as xgps.

/Tim

Tim Lundström wrote:
> Hi,
> 
> Could you please tell us a little about your hardware? What software are
> you using for catching the PPS signal? What is your configuration?
> 
> - From your information I can't tell what's wrong. Are you sure you are
> recieving PPS signals? Are you sure you are recieving them on the right
> pin? Are you sure the GPS is sending PPS signals? The GPS needs a good
> fix before sending PPS.
> 
> /Tim
> 
> Ana Hernandez wrote:
> 
>>>Hi Rob,
>>>
>>>I read your mail, and I have a problem about you said, I have a node
>>>with a GPS Garmin, the signal of pps that I receive is very short, so I
>>>can not to synchronize the node.
>>>
>>> remote           refid      st t when poll reach   delay   offset
>>>jitter
>>>==============================================================================
>>> 127.127.28.0    .SHM.            0 l    -   64    0    0.000    0.000
>>>4000.00
>>>+193.224.70.7    195.111.99.186   2 u  300  512  377   25.619    1.349
>>>0.087
>>>*130.206.169.218 .SHM.            1 u  239  512  377   40.112    1.271
>>>0.085
>>>
>>>The pulses are too short for transmission via RS232.  I try to lengthen
>>>them, 
>>>
>>>/bin/echo -ne "\n\$PGRMC,,$ALTITUDE,,,,,,,,3,,2,48,\n\n" > $GPSDEVICE
>>>
>>>but I can not get to lengthen the pulses, you think that is posible the 
>>>problem is in the wire?
>>>
>>>_______________________________________________
>>>timekeepers mailing list
>>>[email protected]
>>>https://fortytwo.ch/mailman/cgi-bin/listinfo/timekeepers
>>>
> 
> 
> 
_______________________________________________
timekeepers mailing list
[email protected]
https://fortytwo.ch/mailman/cgi-bin/listinfo/timekeepers

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (GNU/Linux)
Comment: Using GnuPG with Fedora - http://enigmail.mozdev.org

iD8DBQFFrOtU/V2VyZDycRcRAq6hAKDDrauBB5I+c8ahB7YDTM4bE04PHACguYbC
1RNUwVfv68eghi4HTNhBBgQ=
=iDRR
-----END PGP SIGNATURE-----
_______________________________________________
timekeepers mailing list
[email protected]
https://fortytwo.ch/mailman/cgi-bin/listinfo/timekeepers

Reply via email to