Hi Peri,
if you have an application which sets or clears the leds according to
received messages, there's nothing for the remote to act upon if the sender
is just switched off. Remember, the remote mote must receive a radio
message where the red led is off. If you just switch the base off, nothing
gets sent. Sorry if I misunderstood what you mean.
Regards,
Harri
At 02:03 AM 1/4/2006 -0800, Thiagraj Peri Natraj wrote:
Hi all,
I have two micaz motes of which one is sitting on a MIB510 board(without
battery) and other micaz mote battery supplied.
I turned on one of LED in the micaz mote sitting on MIB510 and sent the
value over radio by modifying the CntToLedsAndRfm program so that it sends
only the value of one LED ON status (not in counting fashion from 0x00 to
0x07) and in other mote supplied with battery i programmed the RfmToLeds
program to receive the LED status and it was recevied fine.
But, What i expect is when i turn OFF the micaz mote sitting on MIB510, i
expect the LED to get turned OFF on the micaz mote with battery supplied
since the radio connection is lost. Once the micaz mote sitting on MIB510
is off, the radio connection is lost, but still the LED is ON on the micaz
mote with battery.
Is there a way to check in the RfmToLeds Program to display the value of
LED, only if there is radio connection! (that is micaz mote sitting on
MIB510 is OFF) ? and if there is no radio connection make automatically
the LEDs to OFF in the micaz mote with battery supplied.
TIA,
Regards,
Peri
Yahoo! Photos
Ring in the New Year with
<http://us.rd.yahoo.com/mail_us/taglines/photos/*http://pg.photos.yahoo.com/ph//page?.file=calendar_splash.html&.dir=>Photo
Calendars. Add photos, events, holidays, whatever.
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
