If you are using mica2's you should compile everything in the
contrib/xbow tree where there is radio code that actually works.
Also make sure you have defined the right frequencies for your
devices (and you're not mixing 2's with Z's are you?).
If you are using micaZ's you need TOS1.1.10 or greater.
MS
RAKESH KUMAR wrote:
hye guys
i am working on a project which reqires programming with motes...
i am working with mica and micaz....
right now i am able to install programs on motes...
but when i try to verify hardware's. it just give me an error "node
transmission failure" and sometimes bad packet or long packets.
did any body have experience on this. if anybody can help me out that
would be highly appreciated.
i am using tinyos-1.x and moteview.. and hardwares are serial and
parallel cables, mib510,mts300 sensors ..
please help me guys
with thanks and regards Rakesh Kumar Lakhanpal <http://www.rss.org/>
------------------------------------------------------------------------
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
_______________________________________________
Tinyos-help mailing list
[email protected]
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
