Dear sir,
I am a student developing a system in wirelsess sensor nodes.Recently i am
doing some work with the crossbow products..(micaz2,MIB5100,MIB600,TMS300,,,)
At first i use MIB510,usg the serial connector...i just install the micaz to
mib 510(just fix it on the top of it,using the 51 pin..).But then i dont know
how to install the sensor bodes onto micaz2.When i refer to the guideline which
was in the pdf format,sensor boards have to connect/install with the
micaz...But how?
So what i did it is,i saw there is another 51 pins at another side of
MIB510,so i just install the sensor to it...Is that correct??
Second ,i use the the MIB600...i am having the same problem here...i dont
know how the sensor boards have to be installed with micaz...there are housing
provided for the sensor boards....where the housing have battery on bottom of
the housing...sensor boards have to installed with mote assembly board an dthen
only placed it in the housing....But i couldnt find the mote assembly...??we
bought the hardware as one full set...
Sir ,can u explain in brief,how i can use the MIB600,Micaz,sensor
boards.....I really need help...since here in my college nobody have used these
tool before..my project is basically about detecting the environmental
changes....like temperature,humidity...now the main problem is i dont know
about the setup of the tool...and how it works??By the way i am using Mote
view,to collect and view data...
I had been sending mails to quite number of peoples who involved in this ,but
until now there is no reply...
Hope that i will ger a reply...Your explaination very much appreciated....
Thank you...
---------------------------------
Park yourself in front of a world of choices in alternative vehicles.
Visit the Yahoo! Auto Green Center.
_______________________________________________
Tinyos-help mailing list
Tinyos-help@Millennium.Berkeley.EDU
https://mail.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help