Talking about MIB600, dos anyone know how to find out the MAC address of one of these? There's one here whose address has faded from the board.
2007/10/2, Giri Baleri <[EMAIL PROTECTED]>: > > > Here's what you need to do to change the default baud rates for the MIB600. > > 1. Open a web browser and type the IP address of MIB600. You should see > Lantronix web manager page. > 2. From the left hand menu corner, click on Channel 1 and and the default > settings should be: > Serial Port Speed: 115200 > Port :10001 > > 3. From the left hand menu corner, click on Channel 2 and the default > settings should be: > Serial Port Speed: 57600 > Port:10002 > > 4. If you make changes above, save/update the settings. > > I hope that helps, > Giri > > ________________________________ > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On > Behalf Of JeongKwanhee > Sent: Tuesday, October 02, 2007 6:19 AM > To: tinyos-help@Millennium.Berkeley.EDU > Subject: [Tinyos-help] MIB600 115200 > > > > > > Hello! Everybody. > > > > I am trying to change the baud rate from 57600 to 115200 on MIB600. > > However, I cannot operate correctly. I do not know why it is not running. > > > > So, I will write down about my trial for changing rate. > > First, I tried. > > In eprb.extra file, I added –dport=10001 on uisp programming. > > …..is not run.. > > > > Second, I tried. > > I changed HPLUART0M.nc file as follows. > > outp(15, UBRR0L) -> outp(7, UBRR0L) > > …is not run.. > > > > At result of my test, it always runs just to 10002 port(57600bps). > > > > If somebody know how to change the baud rate, please reply to this. > > > > Thank you > _______________________________________________ > Tinyos-help mailing list > Tinyos-help@Millennium.Berkeley.EDU > https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > -- "The truth shall set you free" _______________________________________________ Tinyos-help mailing list Tinyos-help@Millennium.Berkeley.EDU https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help