I'm cc'ing this back to the help-list because I don't use T2 and can't help...
MS
Таня и Руслан Валовые wrote:
In the project ..tinyos-2.x\apps\tests\storage\Block\randrwappc
(for mica2) Atmega128 works with AT45DB without usage Atmega128's USART1
controler (the program control is used).
How to use Atmega128's USART1 controler in this design?
-----Original Message-----
From: Michael Schippling <[EMAIL PROTECTED]>
To: Таня и Руслан Валовые <[EMAIL PROTECTED]>
Date: Thu, 20 Dec 2007 12:15:43 -0700
Subject: Re: [Tinyos-help] (no subject)
start by reading the doc/tutorial
then read through any code that has UART in it's name
in the relevant platform directories.
MS
Таня и Руслан Валовые wrote:
Hello!
I do not know as to configure system so that it used hardware controllers
Atmega128
For example controller UART1.
To default operational systems in the program way operates bus UART1.
With the best regards, Valovoi Ruslan!
_______________________________________________
Tinyos-help mailing list
Tinyos-help@millennium.berkeley.edu
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
--
Platform: WinXP/Cygwin
TinyOS version: 1.x, Boomerang
Programmer: MIB510
Device(s): Mica2, MicaZ, Tmote
Sensor board: homebrew
--
Platform: WinXP/Cygwin
TinyOS version: 1.x, Boomerang
Programmer: MIB510
Device(s): Mica2, MicaZ, Tmote
Sensor board: homebrew
_______________________________________________
Tinyos-help mailing list
Tinyos-help@millennium.berkeley.edu
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
