This works! Thanks a lot for the help. I am using MicaBusC now, but I didn't understand why I shouldn't use HplAtm128GeneralIOC? I checked with HplAtm128GeneralIOC and it works too,though.
On Tue, Jan 8, 2013 at 3:21 AM, András Bíró <andras.b...@ucmote.com> wrote: > Hi, > > > On Tue, Jan 8, 2013 at 1:09 AM, Sid <sid...@gmail.com> wrote: > >> Hi All, >> >> I am fairly new to tinyos 2.x and cannot figure this problem out. I hope >> someone helps me out with this "dumb question". I am trying to send a pulse >> using the GPIO(Port C0) of mica2 mote. But when I am trying to compile the >> code, it gives the error: >> >> In file included from MyProgramAppC.nc:10: >> In component `MyProgramC': >> MyProgramC.nc:7: interface HplAtm128GeneralIO not found >> In component `MyProgramAppC': >> MyProgramAppC.nc:18: no match >> make: *** [exe0] Error 1 >> >> >> Following are the code snippets: >> >> *Wiring:* >> implementation { >> .... >> components HplAtm128GeneralIOC; >> components MyProgramC as App; >> >> .... >> App.Out1 -> HplAtm128GeneralIOC.PortC0; >> ..... >> } >> >> *Implementation:* >> module MyProgramC { >> ... >> uses interface HplAtm128GeneralIO as Out1; >> > > Here's your problem. there's no HplAtm128GeneralIO interface, you should > use the GeneralIO interface here. (By the way, if this gpio is on the 51 > pin connector, you shouldn't use the component HplAtm128GeneralIOC eighter, > use the MicaBusC) > > Andris > > >> .... >> } >> >> >> Any help would be greatly appreciated. I could not find anything in the >> mailing list which will answer this issue. >> >> Thanks, >> John >> >> >> _______________________________________________ >> Tinyos-help mailing list >> Tinyos-help@millennium.berkeley.edu >> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help >> > >
_______________________________________________ Tinyos-help mailing list Tinyos-help@millennium.berkeley.edu https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help