Andy,
I am only using this config to build against the kernel.Here is what I did:
1. Copied the config to arch/arm/configs.
2. make ARCH=arm omap4plus_defconfig
3. make ARCH=arm menuconfig
4. Checked the configuration for "USB_MUSB_OMAP2PLUS" shown below.
Symbol: USB_MUSB_OMAP2PLUS [=m]
│
│ Type : tristate
│
│ Prompt: OMAP2430 and onwards
│
│ Defined at drivers/usb/musb/Kconfig:49
│
│ Depends on: <choice> && ARCH_OMAP2PLUS [=y]
│
│ Location:
│
│ -> Device Drivers
│
│ -> USB support (USB_SUPPORT [=y])
│
│ -> Inventra Highspeed Dual Role Controller (TI, ADI, ...)
(USB_MUSB_HDRC [=y]) │
│ -> Platform Glue Layer (<choice> [=m])
│
The choice state for "Platform Glue Layer" is not reflecting the right
configuration.
--
You received this bug notification because you are a member of TI OMAP
Developers, which is subscribed to linaro-landing-team-ti.
https://bugs.launchpad.net/bugs/1017438
Title:
Panda: adb over usb broken on panda-ics-gcc47-tilt-tracking-
blob/#build=101"
Status in Linaro Android:
New
Status in Linaro Texas Instruments Landing Team:
New
Bug description:
Description:
--------------
adb over USB broken on :
https://android-build.linaro.org/builds/~linaro-android/panda-ics-gcc47-tilt-tracking-blob/#build=101
(Kernel version: 3.4)
Steps:
-------
1. Bootup Android from sd card for above build
2. Connect USB cable after device boots up
3. type <path_to_android_sdk/platform-tools>adb devices -on host machine.
Issue: No device listed.
I do not see USB detection messages on serial console when USB cable
is connected to device.
To manage notifications about this bug go to:
https://bugs.launchpad.net/linaro-android/+bug/1017438/+subscriptions
_______________________________________________
Mailing list: https://launchpad.net/~tiomap-dev
Post to : [email protected]
Unsubscribe : https://launchpad.net/~tiomap-dev
More help : https://help.launchpad.net/ListHelp
