My K3 combined with tlf/hamlib reads frequency/mode nicely both into
cqrlog and to tlf and if necessary simultaneously by use of rigctld
daemon. Some hassle to set up as I had to compile hamlib from source,
the standard install were not found by tlf unless hamlib was compiled.
My question is as follows, why do the K3 return to a wide bandwidth
every time I change bands or turn the vfo outside the bandlimits - this
only happens when the k3 is communicating with tlf. There seems to some
builtin logic that overrides the bw and resets the bw to approx 1000 hz
every time I change band. Is there some logic built into tlf or is this
a hamlib issue?
Any suggestions/tips? I only want the pc to read out the qrg and mode
and not control anything else than the keying if asked to.
73 de LA3RK - Olaf
_______________________________________________
Tlf-devel mailing list
Tlf-devel@nongnu.org
https://lists.nongnu.org/mailman/listinfo/tlf-devel
