Gord, The target noise floor here at my QTH is -130 dBm and I average -128 dBm in all directions except two that average -125 dBm (line noise issues). The signal strength of the DX stations I hear and work vary anywhere from 1 to 15+ dBm above the noise floor. My feedlines vary in length from 120 ft to over 800 ft. I have found with my RX antennas that a preamp does not improve the signal to noise here so I have never used one.
For me, the biggest mistake 160 meter operators make is believing they can erect a low noise RX antenna and begin to magically hear stations that never existed before. Sure, you will hear stations that were previously there but masked by high noise but RX antennas are only one component of hearing DX on 160. The prominent factor is propagation and a lot of times even with the best low noise RX antennas you will just not hear some DX stations and sometimes spot light prop will shine on a small area. I generally never hear some of the stations spotted by W1/W2's in New England or the W3/W4 stations on the east coast. There is a lot of land between there where I am out in the middle of Arkansas. I use and compare 160 meter signals with three other stations; K5UR who is 20 miles SW of me, W5UN who is 200 miles SW and W0FLS who is about 600 miles north. I never try to compare with the stations out east or way down south near the gulf because they just get better prop from EU/AF but if I can't hear what K5UR hears I pooch my lips out and start looking for problems here with the antennas. W5UN and W0FLS are propagation comparisons. So, if you have your Beverages installed correctly and have a nice, low noise floor but stations close to you are hearing DX you aren't you basically have two options 1) wait for the propagation and/or install a second, different type of RX antenna to help with different or varying wave angles. I have four different RX arrays here - Beverages, Vertical Arrays, K9AY Loop and a low dipole. The only area I struggle with hearing, when prop is in, is the 5X & 9U area of Africa. A mystery to me I am yet to resolve (but working like heck on it!! :-)) How far away are the W6/W7 stations you are comparing to and how close to the west coast are they?? 73 ZN On Thu, Feb 14, 2013 at 11:55 AM, Gord Kosmenko <ve...@xplornet.ca> wrote: > A very interesting discussion on RX arrays, but I need to > > ask about the signal strength you guys are actually working > > with using these arrays? > > > > Here at 53 deg N lat and 113 deg W long 160M signal strengths > > are in the ESP region. Having 800 to 1000 foot beverages and > > 4Q RX array for 160M and location that enables me to use AMP1 > > on the rig as noise does not move the S meter signals are just > > darn weak! > > > > My TX vertical provides me to RX with either AMP1 or IPO1 > > on with a noise reading of S1 to S2. Yet DX signals are down at > > ESP level here. > > > > Many 160M DX packet reports even west of me (but south) like > > W7 and W6 cannot be heard by me. > > > > Again what is the signal strength levels are you guys working > > with these arrays? > > > > 73, Gord VE6SV > > > > > > > > > > _________________ > Topband Reflector > -- 73 Joel W5ZN www.w5zn.org _________________ Topband Reflector