Hi Jeff,
Here's how we handle receive antenna switching at W3LPL: Six monoband receiving arrays are located 1000 feet southeast of the transmit antennas. Each monoband receive array feeds a W3LPL bandpass filter and a Clifton Labs Norton Preamplifier in the shack except for 10 meters which uses a Clifton Labs Norton preamp at the center of the 10 meter 4-square array. 160M 8-circle using W8JI 25 foot umbrella verticals 80M 8-circle using W8JI 25 foot umbrella verticals 40M 8-circle using W8JI 14 foot umbrella verticals 20M 4-square using 16 foot verticals 15M 4-square using 11 foot verticals 10M 4-square using 8 foot verticals Three 580 foot Beverages (NE, S, W) are located 1000 feet from the transmit antennas. Each Beverage feeds 160, 80 and 40 meter W3LPL bandpass filters which then feeds three ARR preamps in the shack. Two transceivers are used on each band, mostly Elecraft K-3s and Yaesu FTdx5000s. K9AY receive antenna switches are used with the 160, 80 and 40 meter transceivers to allow all six operators to select one or more receive antennas completely independent of all other operators. The transmit antennas also feed the inputs to the K9AY switches. The only restriction is that the monoband vertical receiving arrays can point in only a single direction on each band, but the Beverages provide the capability for the two operators on each band to receive in different directions. 73 Frank W3LPL ----- Original Message ----- From: "Jeff AC0C" <keepwalking...@ac0c.com> To: "Tom W8JI" <w...@w8ji.com>, "Art Snapper" <a...@nk8x.net> Cc: "160" <topband@contesting.com> Sent: Tuesday, April 21, 2015 3:58:45 AM Subject: Topband: RX antenna switching - multi-rig, multi antenna Art,s question has got me thinking about how the big multi-multi handle a bunch of receiving antennas routed to a bunch of stations? Here I'm looking at up to 8 rx antennas fed to 4 stations. But the more you dig into this, the more complicated it can get. A crossbar-sort of switching arrangement would do the signal routing - but it would not provide any rig to rig isolation and would not maintain a constant Z (important if the rx amp is a norton type). 73/jeff/ac0c www.ac0c.com alpha-charlie-zero-charlie _________________ Topband Reflector Archives - http://www.contesting.com/_topband _________________ Topband Reflector Archives - http://www.contesting.com/_topband