The K3 has two noise blankers. Likely the image you are hearing is caused by the IF noise blanker. If you turn that one off - and just use the DSP one - you will likely find the image disappears.
Whenever possible - if you can deal with a noise just with the DSP blanker - you will be less affected by strong signals that are outside the bandwidth of the selected crystal filter. Tree N6TR On Tue, Dec 8, 2015 at 7:56 AM, Larry - K1UO <k...@tds.net> wrote: > Hello all.. This AM on 160 meters there was a station CQing on 1.820.6 > with a fundamental freq signal strength of S9 on my K3. I also found (with > the NB on) that I could hear him Q5 but very weak on 1.810.6 and the same S > 0 reading but perfectly Q5 on 1.830.6. I turned the noise blanker off and > of course the images disappeared. Is this a know problem when using the NB > or is this just with my radio after a recent factory alignment? I have > had a K3 for years and never noticed anything like that before but then > again this AM was very quiet on 160M and I had the NB on because I could > hear a distant tick tick of an electric fence. > _________________ > Topband Reflector Archives - http://www.contesting.com/_topband > _________________ Topband Reflector Archives - http://www.contesting.com/_topband