> I have e-mailed Palstar but, to date, they have not responded. I would > love it if someone would come up with a high power, fully weatherized, > remote tuner.
I was in a dilemma back in Illinois, I had a Heights 100' aluminium fold over tower but insufficient land to put down sufficient radials in all but one direction. I had though, excellent results in my condo before that, using shortened loop antennas made of copper pipe, mounted in an octagon shape hanging against a wall upstairs. That got me to thinking... I remember reading they were supposed to be 95% transmit-wise, as effective as a dipole at the same height. The Q was so high on 80M that there was only around 3-4 KHz available at the resonant frequency. At first, in the condo, I used a vac variable across the feed point and adjusted it with the Rx in the room. It was like using a crystal radio in that once set, I was essentially rock bound to that frequency; at that resonant frequency I could adjust to 1:1 but past 2 KHz either side and the SWR would be too high. At least I got on the air and could call CQ and I made more than a few ATNO that way. When I moved to the house and had that Heights fold over tower and couldn't put down radials for 80, much less 160, I remembered my fix at the Condo. This time I built short center fed delta loops for 80 and 160, mounted them apex up at the top of the tower, just below the rotor. It looked somewhat like a K9AY mounted at the top with one delta 90 degrees from the other longer delta. I mounted Vac Variables inside plastic sealed mail boxes mounted to the tower at the feed-point, connected them to servos and had the servo counterpart in the shack in the basement in a cabinet with Groth counters attached to each. The Q was less on these antennas because the loops were larger than they were respectively in the Condo. Still a high Q but I could get 5-10 KHz of ideal SWR before needing to re-adjust the servo (Enough I could effectively run split using the Corsair's external VFO). With the sensitivity to resistance you get with the servo, it was instantly obvious when you were at either end of travel with the Vac variable so no chance of damaging the bellow, I could run my legal limit amp with zero problems, ever and regardless of where I was on the band, I had a 1:1 SWR at the feed-point. After a few days of becoming accustomed to the system, it took seconds to get me perfectly on frequency. All you needed to do was listen and adjust. When you were away from resonance, the radio was totally silent except for radio hiss, when you heard the band come alive, you were close to resonance, almost ready and could operate. Look at the SWR and adjust the final couple degrees of turn and you were at 1:1. It worked perfectly, every time, never failed, always gave me 1:1 at the feed-point and considering I had no way to get a really ideal antenna up for 80 & 160, this gave me years of excellent operation on those bands. 73, Gary KA1J _________________ Topband Reflector Archives - http://www.contesting.com/_topband
