I followed the instructions on the W0BTU website, which gave me all the
information I needed to set up three, two-wire Beverages here.
I found the easiest wire to work with for the baluns is what I stripped out
of two-pair indoor telephone wire. It has four colours PVC insulation on
thin solid copper wire, so there is no issue identifying which winding is
which! The advantage of the thin PVC insulated wire is both ease of
identification and little risk of nicking the insulation as it passes
through the (conductive) ferrite cores.
For the Beverage wires, I used 3.0 mm heavy galvanised high-tensile steel
fencing wire. A 1500 m (nearly a mile) coil plus a bit did the job. Spacing
is about 40 mm (about 1.5"). All the hardware is electric fence stuff, I
bought at the local (rural) hardware store.
73,
Luke VK3HJ
-----Original Message-----
From: Fred Moeves
Sent: Friday, May 15, 2020 7:29 AM
To: topband@contesting.com
Subject: Topband: 2 wire reversible Beverage
Hello everyone,
I'm trying to figure out how to wind the transformers for the 2 wire
Beverage.
I have ordered some WD1A wire and will be trying to use that.
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector